Motion Detection Sensors By xcluma

• HW-MS series microwave sensor module according to the Doppler principle, a high-frequency planar antenna for transmitting and receiving electromagnetic waves, then detects that the slight change in movement folded back wave, which triggers the microprocessor operates the final output electrical signal useful control (H -1 / L-0) or a control status (on / off, namely: on / off).
• This product is widely used in security monitoring; intelligent control system; lighting appliances (garage, corridor, roads and other places of use).
• HW-MS series is the latest development of a single-plate microwave sensor module, the product is especially suitable for areas other electronic ultra-thin design of intelligent home appliances, security products, lighting products.
• Effect of 1, independent of temperature, humidity, air, dust, noise, light and dark, etc., anti-jamming; 2, the microwave transceiver module is a field type signal, covering a wide and non-blind; 3, during transmission of microwave induced relatively good: As used indoors, the better; when used outdoors, due to the influence from the environment sensing occurs slightly reduced or slightly weaker sensitivity phenomenon. This is a normal phenomenon, users do not have doubts

• Operating Voltage Range: DC4.5-20V
• Static current: <60uA.
• Trigger: repeatable trigger (default)
• Delay time: Default 8S + -30% (can be customized range of a few tenths - tens of minutes).PCB Board Dimensions: 10 * 23mm
• Induction angle: <100 degree cone angle.Induction distance: 3 meters

• infrared sensor with control circuit board the sensitivity and holding time can be adjusted
• Working voltage range: Dc 45v- 20v current drain:<60ua voltage output: High/low level signal:33v ttl output detection distance: 3--7m(can be adjusted) detection range: <140 degree
• Delay time: 5-200s(can be adjusted, default 5s +-3 percent) blockade time: 25 s (default) trigger: L: Non-repeatable trigger h: Repeat trigger (default) work temperature:-20-+80 degreec trigger method: L unrepeatable trigger / h repeatable trigger dimension: 32cm x 24cm x 18cm (approx)